Imagine taking on a plumbing project with the confidence that you are going to do a good job and that you are going to complete the job for well under the price of hiring professional help. Now use this hopefulness, and take a few minutes to read the great tips in this article.
Rigid copper is used for main water lines in many homes. You cannot bend rigid copper, so joints and tees must be soldered on. When soldering, always apply flux (also called soldering paste) to both surfaces. Flux retards oxidation when the copper is heated. Always use lead-free or nearly lead-free solder when sweating a copper joint.
Before starting any plumbing project be sure to turn off the main water supply. Water damage can be one of the most expensive things to repair. To minimize damage turn the main water supply off as well as any shut off valves near where you are working. This will save a great deal of hardship later on.
If your pipes bang when you turn on the water, and all the pipes are anchored correctly, you should add some straps or cushion the pipes with a rubber blanket. There may be times when you will need to do both. Make sure that if you have copper pipes, you are not using galvanized straps.
Make sure you know where your home’s water shutoff is located. You never know when there might be an emergency involving a broken pipe or damaged connection that requires you to turn off the water right away. In addition, knowing where the shutoff is located is vital before you start any plumbing project, in case anything goes wrong.
Do not overload your garbage disposal. If you need to dispose of large items, cut them up into smaller pieces. Also, do not put too much in at a time, put one or two items in and wait a few seconds to dispose of the rest. Overloading your disposal can cause the engine to overheat.
To lessen the chances of toilet problems, do not use as a place to put trash. Keep away from flushing improper items down the toilet, like cotton balls, diapers, paper towels, or feminine hygiene products. These types of items can clog your toilet as they do not dissolve. As well, use just enough toilet paper to clean yourself!
Do not forget to check the temperature of the water heater in your house, especially if you are planning to leave for an extended period of time. You should keep the temperature no higher than 120 degrees, which will help to reduce energy use and prevent your system from burning out.
Do a routine check around your house each month on each and every faucet to make sure there are no signs of leaks or drips. Over time, leaks can add a lot of money to your water bill and will worsen if you do not take care of the problem.
To summarize, you want to know that you are taking care of your plumbing job just the same as a professional would, but without the additional costs they would inflict upon you. Hopefully, this article was informative enough for you to tackle any plumbing issue that might come your way.…